[OpenTRV-dev] Motor Drive

[Bo Herrmannsen]

i can make an eagle library for this one.. does not seem so bad to hand
solder... will look more at the specs tomorrow

2013/6/14 Stuart Poulton <EMAIL ADDRESS HIDDEN>

> Anyone else interested, will be ordering late Sunday or early Monday
> On 14 Jun 2013 16:24, "Stuart Poulton" <EMAIL ADDRESS HIDDEN> wrote:
>
>> Hi,
>>
>> OK, I'll see if there's any more interest, probably ordering tomorrow
>> evening once I dry out.
>> On 14 Jun 2013 15:35, "Damon Hart-Davis" <EMAIL ADDRESS HIDDEN> wrote:
>>
>>> Oh yes please!  1 or 2 please.
>>>
>>> Equally I could order on the company card and could pass on 1 or 2 to
>>> you...
>>>
>>> Rgds
>>>
>>> Damon
>>>
>>>
>>> On 14 Jun 2013, at 13:04, Stuart Poulton wrote:
>>>
>>> > Hi Folks,
>>> >
>>> > I know we've talked in the past about the TI DRV8837 chip to do motor
>>> control, of course one of the 'problems' is the size of the chip, I've
>>> found a supplier in the US that has a breakout board (circular) availble
>>> for $4.95 per board, with $4.95 USPS shipping.
>>> >
>>> > Before I order a couple of boards myself, is anyone else interested ?
>>> >
>>> > Thanks
>>> >
>>> > Stuart
>>> > _______________________________________________
>>> > OpenTRV-dev mailing list
>>> > EMAIL ADDRESS HIDDEN
>>> > http://lists.opentrv.org.uk/listinfo/opentrv-dev
>>>
>>>
> _______________________________________________
> OpenTRV-dev mailing list
> EMAIL ADDRESS HIDDEN
> http://lists.opentrv.org.uk/listinfo/opentrv-dev
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.opentrv.org.uk/pipermail/opentrv-dev/attachments/20130615/ff28eaf2/attachment.html>