[OpenTRV-dev] Mass box printing

[Bo Herrmannsen]

btw...

should i print a few and send your way?

/bo

Den 26/11/2013 kl. 21.00 skrev Damon Hart-Davis:

> Hi,
> 
> There will probably be at least one more revision, but the current (3rd) capture in SCN (dated yesterday) is good to try.
> 
> Rgds
> 
> Damon
> 
> 
> On 26 Nov 2013, at 19:34, Bo Herrmannsen <EMAIL ADDRESS HIDDEN> wrote:
> 
>> ah
>> 
>> going big :-D
>> 
>> is the stl on svn the curent stuff to print? or should i hold back?
>> 
>> 
>> Den 26/11/2013 kl. 20.31 skrev Damon Hart-Davis:
>> 
>>> Hi,
>>> 
>>> Yes, I know that you can do it, but I should find one local bulk supplier so I can turn round a large order quickly, eg if we build another 100 units!
>>> 
>>> Rgds
>>> 
>>> Damon
>>> 
>>> 
>>> On 26 Nov 2013, at 19:21, Bo Herrmannsen <EMAIL ADDRESS HIDDEN> wrote:
>>> 
>>>> I can do that...
>>>> 
>>>> just need to relly fine tune printe...
>>>> 
>>>> this involves level surface... level the bed... and make sure all axis are ok
>>>> 
>>>> should have it done in an hour or
>>>> 
>>>> /bo
>>>> 
>>>> Den 26/11/2013 kl. 18.03 skrev Damon Hart-Davis:
>>>> 
>>>>> Hi,
>>>>> 
>>>>> I would like to have a small number of the current OpenTRV box design printed by (say) 2 different organisations in preparation for printing up 40 or more very soon for the trial, to find out who is reliable and produces good prints and is easy to deal with.
>>>>> 
>>>>> Would you like to suggest one or more to test out in this way?  Might be commercial or not (eg TVRRUG).
>>>>> 
>>>>> Rgds
>>>>> 
>>>>> Damon
>>>> 
>>> 
>> 
>