[OpenTRV-dev] round3 firmware

[Stuart Poulton]

I suspect this should have gone to another list.

I don't see that distributing 3D printer code falls under the remit of openTRV.

Stuart

On 25 Jan 2014, at 09:59, Damon Hart-Davis wrote:

> Hi,
> 
> I’m not sure that I understand your question, since I don’t see why that code would be *in* our system as opposed to just being used to physically build it.
> 
> The licence seems pretty explicitly hostile to being used in any commercial printer/CNC sale setting so would not fit with our Apache use cases were that code bundled with OpenTRV, but I don’t think it applies.
> 
> You’d have to ask Malcolm if he believes there is a conflict with the origins of your printer and that licence; I suspect not.
> 
> But tell me if I’ve mis-understood.
> 
> Rgds
> 
> Damon
> 
> 
> On 24 Jan 2014, at 21:49, Bo Herrmannsen <EMAIL ADDRESS HIDDEN> wrote:
> 
>> Hi all
>> 
>> a small q while doing extensive squareness check on my printer..... will our firmware be able to hold the newest marlin found here: https://github.com/ErikZalm/Marlin
>> 
>> its not the one from bus error i know.... i just thought it might be better ????
>> 
>> 
>> /bo
>> 
>> _______________________________________________
>> OpenTRV-dev mailing list
>> EMAIL ADDRESS HIDDEN
>> http://lists.opentrv.org.uk/listinfo/opentrv-dev
> 
> _______________________________________________
> OpenTRV-dev mailing list
> EMAIL ADDRESS HIDDEN
> http://lists.opentrv.org.uk/listinfo/opentrv-dev