<div dir="ltr">I've finally found time to unbox my Radbots.   The plan is to build a combined stats hub and boiler controller based on a RPi.<div><br></div><div>I've successfully compiled the code Christoph shared (<a href="https://github.com/wintersteiger/wlmcd">https://github.com/wintersteiger/wlmcd</a>) and used to to show the one Radbot I've powered up transmits and that I can receive the frames using a CC1101/RPi combination.  Of course the decryption fails as I've yet to set a decryption key.</div><div><br></div><div>I'm struggling to get a connection over the serial port to the Radbot.  I'm trying to follow the instructions shared by Tristan (<a href="https://github.com/tyrken/heatmon/wiki/Reprogramming-Radbot-TRVs">https://github.com/tyrken/heatmon/wiki/Reprogramming-Radbot-TRVs</a>) but I can't seem to get any comms over the serial port.</div><div><br></div><div>I've opened up my radbot to get better access to the pads.</div><div>I'm powering the Radbot from a bench power supply at 3.0V</div><div>I've got a USB serial dongle operating at 3.3V logic, grounded to the -ve supply.</div><div>I think I'm hold the rx/tx lines on the pads (tx from my dongle to rx on the radbot and rx on the dongle to tx on the Radbot), but I get nothing from 'screen' that I'm using for my terminal.</div><div><br></div><div>As far as I know I'm using 4800baud, 8-N-1 (screen /dev/ttyUSB0 4800), which I believ to be the expected settings?</div><div><br></div><div>Can anyone see anything that I'm doing wrong or give me a pointer to things that I can try. ?</div><div><br></div><div>Thanks,</div><div>Rob.</div><div><br></div><div><br></div></div>