[OpenTRV-dev] Valve in place

[Bo Herrmannsen]

hmm…

i also have a kind of tape that melts together after a few hours… works this way.:

you measure the length you need and then you peel off the back side and then stretch it to activate. then you put it on thight. i use it for wire joints that needs to be 100% water thight etc

could that be used? it will not "unmelt" under heat… not from this kind of heat anyway


/bo

Den 19/03/2013 kl. 13.59 skrev Mike Stirling:

> PTFE tape is probably ideal.
> 
> Bo Herrmannsen <EMAIL ADDRESS HIDDEN> wrote:
> 
>> a bit of a false alarm…. while the adapter does not fit (if you thighten the screw all the way in the valve will not bite to the thread) so what i did was just applying a few more rounds of tape and thighten it as much i could. now valve fits and no error beeps
>> 
>> might have to replace the tape with duct tape or something more heat resistant… would think they made the adapters a bit to thight instead of to loose
>> 
>> 
>> /bo
>> _______________________________________________
>> OpenTRV-dev mailing list
>> EMAIL ADDRESS HIDDEN
>> http://lists.opentrv.org.uk/listinfo/opentrv-dev
> _______________________________________________
> OpenTRV-dev mailing list
> EMAIL ADDRESS HIDDEN
> http://lists.opentrv.org.uk/listinfo/opentrv-dev