[OpenTRV-dev] Valve in place

[Damon Hart-Davis]

I wouldn't do anything that would stop you getting that TRV off again if it failed, or for when we have our own OpenTRV valve-driver mechanism!  B^>

Rgds

Damon


On 19 Mar 2013, at 13:03, Bo Herrmannsen wrote:

> hmm…
> 
> i also have a kind of tape that melts together after a few hours… works this way.:
> 
> you measure the length you need and then you peel off the back side and then stretch it to activate. then you put it on thight. i use it for wire joints that needs to be 100% water thight etc
> 
> could that be used? it will not "unmelt" under heat… not from this kind of heat anyway
> 
> 
> /bo
> 
> Den 19/03/2013 kl. 13.59 skrev Mike Stirling:
> 
>> PTFE tape is probably ideal.
>> 
>> Bo Herrmannsen <EMAIL ADDRESS HIDDEN> wrote:
>> 
>>> a bit of a false alarm…. while the adapter does not fit (if you thighten the screw all the way in the valve will not bite to the thread) so what i did was just applying a few more rounds of tape and thighten it as much i could. now valve fits and no error beeps
>>> 
>>> might have to replace the tape with duct tape or something more heat resistant… would think they made the adapters a bit to thight instead of to loose
>>> 
>>> 
>>> /bo
>>> _______________________________________________
>>> OpenTRV-dev mailing list
>>> EMAIL ADDRESS HIDDEN
>>> http://lists.opentrv.org.uk/listinfo/opentrv-dev
>> _______________________________________________
>> OpenTRV-dev mailing list
>> EMAIL ADDRESS HIDDEN
>> http://lists.opentrv.org.uk/listinfo/opentrv-dev
> 
> _______________________________________________
> OpenTRV-dev mailing list
> EMAIL ADDRESS HIDDEN
> http://lists.opentrv.org.uk/listinfo/opentrv-dev
>