[OpenTRV-dev] box for SSR

[Bo Herrmannsen]

So i came to this

i figured i could just reuse the box for opentrv

so far i have removed the usb hole and the ones for antenna and power and left the boiler one

now for the mains wire i want a 10mm hole so a rubber gromet can be fitted and allow the mains wire to go through.... i figured layer 3 which is just a spacer would make do... thou it needs to be higher...

about 4mm higher so there is 2 mm as a bare minimum on each side...

top layer i need to look at... basic it should just be a lid with no holes.... and a high voltage warning of some sort


@bruno..... hate to pester a busy man... but how much effort would it take you to mix the above ideas in to the mix?

not that i cant figure it myself with a few hours... its more that you prop have most of it in your head and would find it disturbing to have to mix it in later....