[OpenTRV-dev] box for SSR

[Bo Herrmannsen]

almost got a box done

missing; 10mm hole.... and dont know where to place it or how to create it.. to keep box height it could be placed so some of the hole are on same layer as boiler hole and the rest in next layer


Q: what defines the hole for buttons etc on top layer ? and mount posts for mini pcb? i have created 2 new files which are just a copy of the opentrv box... for SSR thou we dont need that big a hole.... only need to add a 3mm hole somewhere on lid

/bo

Den 28/11/2013 kl. 11.55 skrev Bo Herrmannsen:

> So i came to this
> 
> i figured i could just reuse the box for opentrv
> 
> so far i have removed the usb hole and the ones for antenna and power and left the boiler one
> 
> now for the mains wire i want a 10mm hole so a rubber gromet can be fitted and allow the mains wire to go through.... i figured layer 3 which is just a spacer would make do... thou it needs to be higher...
> 
> about 4mm higher so there is 2 mm as a bare minimum on each side...
> 
> top layer i need to look at... basic it should just be a lid with no holes.... and a high voltage warning of some sort
> 
> 
> @bruno..... hate to pester a busy man... but how much effort would it take you to mix the above ideas in to the mix?
> 
> not that i cant figure it myself with a few hours... its more that you prop have most of it in your head and would find it disturbing to have to mix it in later....