[OpenTRV-dev] UI simplification

[Damon Hart-Davis]

On 23 Oct 2014, at 12:17, Bo Herrmannsen <EMAIL ADDRESS HIDDEN> wrote:
> 
> but the idea of not needing a manuel is good.... must be sure the TRV is as easy as mechanical ones..
> 
> while on the subject... make sure users can jump modes more easy than on say rev1.. i had a hard time figuring what mode i was in. Also when i say enabled boost mode it would take 1-2 minutes before the LED showed the change.. until i remembered this i thought i did not change mode
> 
> also when i use learn the unit jumped back to frost once the learn period was over.. made it a chilly experience when outside temp was -20 :-D should it not jump back to warm but at reduced temp?

Those would be separate changes to this, though I do now have an extra LED to play with which may help…

Note however that the frost setback temperature in ‘comfort’ mode is now 12C, which is a little less chilly than before (5C)!

But thanks for bringing those up too; I’m going to JIRA the second now.

Rgds

Damon